To check the IMEI
(International Mobile
Equipment Identity)
Type- *#06# Information
you get from the IMEI-
XXXXXX XX XXXXXX X TAC FAC SNR SP
TAC = Type approval code
FAC = Final assembly code
SNR = Serial numbe
r SP = Spare To check the phones
Software revision type-
*#0000#
Information you get from
the Software revision- V
05.31 18-02-99 NSE-3 1ST Line = Software revision
2ND Line = The date of the
software release
3RD Line = Phone type To enter the service menu
type- *#92702689#
(*#WAR0ANTY#)
Serial number (IMEI)
Production date (MM/YY)
Purchase date (MM/YY) You can only enter the date
once. Date of last repair
(0000=No repair) Transfer
user data to another Nokia
phone via Infra-Red.

Clock Stopping
To check weather your SIM
Card supports clock
stopping type-
*#746025625#
(*#SIM0CLOCK#) Revealing the Headphone
and Car-Kit menus
Please note that if you do
these next tricks, the new
menus can't be erased
without retoring the factory default settings. To
do these tricks you need to
short-circuit the pins on
the bottom of the phone
next to where you plug in
you charger. 1. To activate the "Headset" menu, you
need to short- circuit pins
"3" and "4". After a short
time the word "Headset"
will be shown in the
display. Menu 3-6 is now enabled.
2. To activate the "Car"
menu, you need to short-
circuit pins "4" and "5".
After a short time the
word "Car" will be shown in the display. Menu 3-7 is
now enabled.

THE REBOOT TRICK
This should work on all
software versions of the
6110.
1. Go to the Calendar (Menu- 2. Make a note or reminder. 3. Enter some
text into the edit box. 4.
Hold "Clear" until the whole
text is cleared, then press
"Back". 5. Press "0". The
main screen will now be showing but a space
appears on the screen.
(you can't see it) 6. Enter 4
digits (e.g. 1234). 7. Use the
down arrow to move the
cursor to the left side of the numbers and the space
(Down arrow twice). 8.
Now enter 6 digits and
press the call button. Wait
for a few seconds, the
screen should start to flash and reboots. It should
alsowork on other menus
like the "Profiles" menu.

NETWORK MONITOR There
is a hidden menu inside
your Nokia phone. If you
want to activate it, you'll
have to re-program some
chips inside of your phone. 1. Check your software
version. You can only
continue if you have v4.33,
v4.73 or v5.24. 2. Take
apart the phone. 3. De-
solder the EEPROM (ATMEL AT 24C64). 4. Read out the
data with an EEPROM
programmer and save it to
a file (Backup). 5. If you
have v.33 or v4.73, change
the address "03B8" from "00" to "FF". 6. If you have
v5.24 then change the
address "0378" from "00"
to "FF". 7. Write the new
data to the EEPROM and
solder it back to the phone, 8. Power on your phone
and you should have
"Netmonitor" enabled. The
Network Monitor gives
you the following
information. Carrier number MS RX Level in DBM
Received signal quality MS
TX power level C1 (Path
loss criterion, used for cell
selection and reselection).
The range is -99 to 99. RTL (Radio link timeout).
Timeslot Indication of the
transmitter status
Information on the
Network parameters. TMSI
(Temporary Mobile Subscriber Identity). Cell
identification (Cell ID,
Number of cells being
used). MCC (Mobile country
code) MCN (Mobile network
code) LAC (Location area code) Ciphering (On/Off)
Hopping (On/Off) DTX (On/
Off) Discard cell barred
information. SIM-LOCK CHECKS
#PW+1234567890+1# =
GIVES PROVIDER-LOCK
STATUS
#PW+1234567890+2# =
GIVES NETWORK-LOCK STATUS
#PW+1234567890+3# =
GIVES COUNTRY-LOCK
STATUS
#PW+1234567890+4# =
GIVES SIM-CARD-LOCK STATUS.